Immergas Victrix Pro 80 2ErP - 1 Installazione caldaia; 1.1 Avvertenze di installazione.; 1.2 Dimensioni principali.; 1.3 Dima allacciamento.

1
OK
6
INSTALLER
USER
MAINTENANCE TECHNICIAN
1
BOILER INSTALLATION.
1.1 INSTALLATION RECOMMENDATIONS.
ATTENTION:
operators who install and service the
appliance must wear the personal
protective equipment required by ap-
plicable law.
ATTENTION:
Individual and cascade installation Vic-
trix Pro 80-100-120 2ErP boilers can be
installed outdoors or in a suitable plant room).
e installation must comply with all laws and stand-
ards in force.
e place of installation of the appliance and relative
Immergas accessories must have suitable features
(technical and structural), such as to allow for (always
in safe, ecient and comfortable conditions):
- installation (according to the provisions of technical legisla-
tion and technical regulations);
- maintenance operations (including scheduled, periodic,
routine, special);
- removal (to outdoors in the place for loading and transport-
ing the appliances and components) as well as the eventual
replacement of those with appliances and/or equivalent
components.
e wall surface must be smooth, without any protrusions or
recesses enabling access to the rear part. ey are not designed
to be installed on plinths or oors (Fig. 1) but exclusively for
wall installation.
By varying the type of installation the classication of the boiler
also varies, precisely:
- Type B
23
or B
53
boiler if installed using the relevant terminal
for air intake directly from the room in which the boiler has
been installed.
- Type C boiler if installed using concentric pipes or other types
of pipes envisioned for the sealed chamber boiler for intake
of air and expulsion of ue gas.
Note: appliance classication is provided in the de-
pictions of the various installation solutions shown
on the following pages.
Only professionally enabled companies are authorised
to install Immergas gas appliances.
Installation must be carried out according to regula-
tion standards, current legislation and in compliance with local
technical regulations and the required technical procedure.
ATTENTION:
It is not permitted to install boilers that
are removed and decommissioned from
other systems. e manufacturer declines all li-
ability for damages caused by boilers removed
from other systems or for any non-conformi-
ties of such equipment.
ATTENTION:
check the environmental operating
conditions of all parts relevant to in-
stallation, referring to the values shown in the
technical data table in this booklet.