Immergas Victrix Pro 80 2ErP - 2.1 General warnings.

28
INSTALLERUSER
MAINTENANCE TECHNICIAN
2
INSTRUCTIONS FOR USE AND
MAINTENANCE.
2.1 GENERAL WARNINGS.
ATTENTION:
• Access to the heating control unit and
therefore use and adjustment of the
device is only allowed to individuals
envisioned by current law, which are
respectively:
- system manager;
- system conductor;
- third manager.
• For safety purposes, check that the air in-
take/ue exhaust terminals (if tted) are not
blocked.
• If temporary shutdown of the boiler is re-
quired, proceed as follows:
a) drain the heating system if antifreeze is
not used;
b) shut-o all electrical, water and gas sup-
plies.
• In the case of work or maintenance to
structures located in the vicinity of ducting
or devices for ue extraction and relative
accessories, switch off the appliance and
on completion of operations ensure that a
qualied technician checks eciency of the
ducting or other devices.
• Never clean the appliance or connected parts
with easily ammable substances.
• Never leave containers or ammable sub-
stances in the same environment as the
appliance.
• Do not open or tamper with the appliance.
• Do not take apart or tamper with the intake
and exhaust pipes.
• Only use the user interface devices listed in
this section of the booklet.
• Do not climb on the appliance, do not use
the appliance as a supporting surface.
In the case of maintenance interventions on the boiler
that lead to the closure of one or both system cut-o
cocks, the boiler must be o.
ATTENTION:
e use of components involving use of
electrical power requires some funda-
mental rules to be observed such as:
- do not touch the appliance with wet or moist
parts of the body; do not touch when bare-
foot;
- never pull electrical cables;
- the appliance power cable must not be re-
placed by the user;
- in the event of damage to the cable, switch
off the appliance and contact exclusively
qualied sta for replacement;
- if the appliance is not to be used for a certain
period, disconnect the main power switch.
ATTENTION:
water at a temperature of more than
50 °C can cause serious burns. Always
check the water temperature before any use.
The temperatures indicated by the display have a
tolerance of +/- 3°C due to environmental conditions
that cannot be blamed on the boiler.