What to do if my Immergas Boiler shows no ignition block?
If your Immergas Boiler doesn't switch on when you request central heating or hot water, especially after first use or a long break, you might need to clear a block. To do this, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP displays a flow NTC probe in short circuit, and what should I do?
If your Immergas Boiler's board detects a short circuit on the flow NTC probe, press the Reset button.
What to do if my Immergas Boiler displays a P.C.B. error?
If your Immergas Boiler detects an error on the P.C.B. and doesn't start up, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a gas valve electric circuit anomaly, and how can I fix it?
If the board detects an anomaly in the gas valve circuit, before replacing the board, verify the absence of short circuits on gas valve and related connector. Press the Reset button.
What does it mean if my Immergas Boiler displays a flue temperature anomaly, and how can I fix it?
If your Immergas Boiler detects an excessively high temperature reading in the flue circuit and shuts off, it indicates a flue temperature anomaly. To address this, press the Reset button.
What does it mean if my Immergas Victrix Pro 80 2ErP Boiler displays a fan signal anomaly, and how do I fix it?
A fan signal anomaly on your Immergas Boiler indicates the fan speed is incorrect. To attempt to resolve this, press the Reset button.
What to do if my Immergas Boiler has a parasite flame block?
A parasite flame block during power-on can occur due to a leak in the detection circuit or an issue with the flame control unit. In this case, press the Reset button.
What to do if my Immergas Victrix Pro 80 2ErP displays insufficient system pressure?
If your Immergas Boiler switches off due to low system pressure, check the pressure gauge. Ensure the pressure is between 1 and 1.2 bar, and restore it if necessary.
What should I do if my Immergas Victrix Pro 80 2ErP Boiler displays a flame circuit anomaly?
If your Immergas Boiler detects an anomaly in the electronic flame control circuit during ignition and shuts off, press the Reset button.
What does it mean when my Immergas Victrix Pro 80 2ErP shows an overheating block, and what should I do?
If your Immergas Boiler overheats during normal operation due to a fault, it will go into an overheating block. To resolve this, press the Reset button.
To Next Page
General