Intended use
6
2
2
IMT Analytics AG
This product is intended for testing and calibration purposes on medical devices
or systems that generate gas flows or gas pressures. That includes ventilators and
anaesthetic machines. The user of the device has received training on how to use
medical equipment and can perform repairs, maintenance and servicing on medical
devices. The device can be used in hospitals, in clinics, at device manufacturers or at
independent service companies that perform repairs or servicing on medical devices.
FlowAnalyser PRO is intended for use in a laboratory environment. The device must
be placed in a position that the display is readable by the user without impairment. It
may only be used outside the nursing sector. It must not be used directly on patients
or devices that are connected to patients. The measuring instrument FlowAnalyser
PRO is intended for over-the-counter sale.
FlowAnalyser PRO is the solution for measurements in the following areas:
• Flow (-300 – 300 L/min)
• Ultra-low flow (-1–1 L/min)
• Volume
• High differential pressure (-250 – 250 mbar)
• Low differential pressure (-10 – 10 mbar)
• High pressure/vacuum (-1 – 10 bar)
• Ambient pressure (500 – 1240 mbar)
• Oxygen (0 – 100 vol %)
• Temperature (0 – 50 °C)
• Humidity (0 – 100 %)
• Channel pressure (-50 – 160 mbar)
In addition, variousventilation parameters can be measured:
• Inspiratory tidal volume, expiratory tidal volume
• Inspiratory minute volume, expiratory minute volume
• Volumen
• Post-Inspiratory Pause %Tp
• Breath Rate
• I:E
• Inspiratory time, expiratory time
• Inspiratory hold time, expiratory hold time
• P
peak
• P
mean
• P
plateau
• PEEP
• PF Insp (inspiratory peak flow)
• PF Exp (expiratory peak flow)
• Ti/T
cyc
• C
stat
2 Intended use
To Next Page
Loading...
Need help?
General
