8
Safety instructions
3
IMT Analytics AG
This User Manual uses the representation below to specifically draw attention to
residual risksduring intended use andemphasise important technical requirements.
Information and/or instructions and prohibitions shall be observed to
prevent damage of any kind.
Work on and with FlowAnalyser PROmay only be performed by
persons whohave undergone appropriate technical training andhave
the necessary experience.
Themanufacturer accepts no responsibilityor guarantee and willbe exempt fromli-
ability claims accordinglyif theoperatoror any third parties:
• fail to use the device in accordance with its intended use
• disregard the specifications
• tamper with the device in any way (conversions, modifications, etc.)
• operate the device with accessories that are not listed in theassociatedsets
of product documentation.
Although the devicemeets high quality and safety standards andit
has beenconstructed and tested according to the current state
of the art,it is not possible to rule outthe risk of injuries withseri-
ousconsequencesif the device is not used in compliance with the
intended use (used improperly) or is misused. Therefore, please read
through this User Manual carefully and keep this documentation in a
readily accessible place close to your device.
If you have received the device with damaged packaging, please contact the office
listed below.
Customer service
Email: customerservice@imtanalytics.com
If you are aware of an incident, please contact the office listed below.
Technical support
Tel: +41 (0)81 750 67 10
Email: techsupport@imtanalytics.com
Themaximum service life of the devicehas been specified as 10(ten)years,provided
it is handled properly in accordance with this User Manual.
3.1 Representation of hazards,
cautions and notes
3 Safety instructions
3.2 Personnel
3.3 Responsibility and guarantee
3.4 Service life
To Next Page
Loading...
Need help?
General
