47
Servicing and maintenance
10
IMT Analytics AG
Careful servicing in compliance with the instructions is essential for ensuring that
FlowAnalyser PROoperates safely andefficiently. Only components recommended
by the manufacturer may be used.
It isabsolutely essential tocomply with the guidelines andservicing
instructions issued by thevarious manufacturers.
The servicing operations listed below may only be performed by per-
sons whoare familiar with FlowAnalyser PRO. All further repair work
may only be performed by authorised trained professionals. Please
also observe the information issued by the various manufacturers.
Toensure that your deviceoperates with precision and reliabilityfor as long as possi-
ble,it is essential to perform the following servicing routines regularly while the device
is switched off:
During operation
Use of the filter included
After each use
The outer surface of the device enclosure shall withstand wipe disinfection with a
cloth moistened with ethanol or isopropyl alcohol.
Every four weeks
Visually check the protection filter for dust or contamination. Replace the filter if con-
tamination is visible.
Every 12 months:
Factory calibration to ensure reliable measurement. To have FlowAnalyser PRO
calibrated at the manufacturer's, IMT Analytics AG, visit the website
www.imtanalytics.com/easycal
10 Servicing and maintenance
10.1 Guidelines for servicing and
care
10.2 Notes about changing parts
10.3 Preventive cleaning and
servicing routines
To Next Page
Loading...
Need help?
General
