Inateck BCST-10 - Chapter 2: Bluetooth Connectivity

Chapter 2 How to Connect with BT
1. Make BCST-10 full charged, press Power key. If the scanner never
connected with the computer before, it will responds with a beep,
and flashing red.
2. Have the scanner read the "Enter Setup" barcode to enter the
setting mode.
3. Have the scanner read the associated barcode to activate the BT
connection interface.
4. Have the scanner read the barcodes for related settings.
5. Have the scanner read the barcode to exit the setting mode.
6. The BCST-10 Scanner will stay active for 1 minute waiting for a
connection request from the host(SPP) or trying to connect to the
host(HID).
Contents
2.1.Select Output Interface..............................................................24
2.1.1 BT SPP Mode...................................................................24
2.1.2 BT HID Mode....................................................................24
2.2 Setting up a BT connection........................................................25
2.3 Connect to PC via BT.................................................................26
2.4 Connect to PDA via BT...............................................................31
2.4.1 One-click Android Connection.....................................36
2.4.2 One-click iOS Connection...........................................39
2.4.3 Connect via BT Input Method......................................42
23