Inateck BCST-10 - Output Interface Selection

2.1. Select Output Interface
Either SPP or HID can be chosen depending on the need.
2.1.1 BT SPP Mode
If you select the output interface of BT SPP, you may run
HyperTerminal.exe or serial port tool to collect the scanned data.
You can setup SPP data batch upload or single upload according to
your requirements.
2.1.2 BT HID Mode
By default, BT HID is activated on the BCST-10 Scanner, and the
keyboard type is set to PCAT (US).
Enable SPP
SPP Data Batch Upload
SPP Data Single Upload
(*)Enable HID
Enter Setup
Exit with Save
Exit without Save
24