8-13
6725$*($1':,17(5/$<˨83
© 2020 Indmar Marine Engines
REACTIVATING ENGINE AFTER EXTENDED STORAGE
NOTICE
Use caution when connecting the battery cables. Improperly
connecting the battery cables or using the wrong battery type can
damage electrical components. These damages are not covered
by your warranty.
1. Charge and reinstall the battery in the boat. Make sure the
terminals are clean and tight.
2. Reinstall the cap or the small hose on the tee fitting that is part
of the hose that goes between the two exhaust manifolds.
3. Reinstall the water pump impeller. Be sure to use a new gasket
for the housing cover.
4. Reinstall the anode/drain plug in the raw water side of the heat
exchanger. Apply pipe thread sealant to the threads to make
sure there are no leaks.
5. Inspect the accessory drive belt and make sure that it is routed
properly.
6. If the fuel tank was drained, fill the tank with fresh stabilized
fuel that does not contain alcohol.
7. Check all fluid, oil, and coolant levels on the engine and drive
train.
8. Check the engine compartment and bilge for nesting animals.
Clean as necessary. Check for any damage or evidence of
fluid leaks.
To Next Page
Loading...
