4-1
© 2020 Indmar Marine Engines
Section Four
),567˨7,0(23(5$7,21$1'%5($.˨,1
Before operating or maintaining the engine, review “Safety” on
page 1-1.
!
WARNING
Always operate the bilge blower at least 4
minutes prior to starting the engine. Raise the
engine cover to ventilate fumes. Inspect the
engine and compartment for any fluid or fuel
leaks.
NOTICE
A new engine may use a more than normal amount
of engine oil before it is broken in. Check your oil
level hourly during the break-in period. Once the
engine is broken in, check the oil level before each
day’s use and more often during sustained periods
of high RPM or heavily loaded operation. Marine
usage is different from automobile usage and oil
consumption is EXPECTED. Do not be alarmed if
you have to add oil between oil changes.
),567˨7,0(23(5$7,21
1. Perform the Pre-Start Checks. Refer to “Section 3.”
2. Back the trailer into the water. NOTICE: Make sure the engine
water intakes are not blocked by the trailer bunk and the water
intake is submerged.
To Next Page
Loading...
