6-2
SECTION SIX
NOTICE
Do not allow excessive amounts of water to remain in the bilge.
Component damage due to water is not covered by the warranty.
Water can also be ingested through the flame arrestor if bilge
water level is too high.
2. Follow the starting procedures outlined in Section 5, Engine
Starting Procedures.
3. Once the engine is started, allow it to reach operating
temperatures of at least 120°-140°F (49°-60°C) before
accelerating to speeds above 3000 RPM.
INDM-A015
Figure 6.1 – Typical Temperature Gauge
4. Monitor your gauges and warning lights frequently to ensure
that engine temperatures and pressures are within the proper
ranges.
INDM-A014
Figure 6.2 – Typical Oil Pressure Gauge
To Next Page
Loading...
