4-3
),567˨7,0(23(5$7,21$1'%5($.˨,1
© 2020 Indmar Marine Engines
Engine Start
Typical Start/Stop Keypad
12
56
34
78
90
START
STOP
Enter Code:
XXXX
Figure 4.2 – Basic Keypad
OTE: N Some boat manufacturers use touch pad starting rather
than key switches. Refer to the boat operator’s manual if
your boat is so equipped.
4. WARNING! Operate the bilge blower for at least 4
minutes. Start the engine (Refer to Section 5, Engine
Starting Procedures) and allow it to reach normal operating
temperature;
keep a close eye on the gauges. If any of
the gauges indicate an engine problem, stop the engine
immediately and bring the boat to your Indmar dealer for
assistance. NOTICE: Do not operate the starter motor for than
15 seconds without a 2 minute cooldown period. Excessively
long cranking times will permanently damage the starter motor
and drain the battery.
%5($.˨,1
Taking care now to break-in your new Indmar engine is VERY
important. When properly broken in, your engine will last longer,
run better and require fewer repairs over its lifetime. Your new
Indmar engine does not require an elaborate break-in procedure,
just a little care and common sense for the first 10 hours.
To Next Page
Loading...
Need help?
General