7-27
MAINTENANCE
© 2020 Indmar Marine Engines
(/(&75,&$/6<67(0
The electrical system on all Indmar engines is protected by a 40A
main circuit fuse. If the engine will not crank with the battery switch
in the ON position, locate the fuse in the electrical box on the
engine. Remove the cover from the electrical box and check the
40A fuse. If the fuse is blown, there is a spare in the electrical box.
There are also other spare fuse locations in the electrical box.
Always keep spare fuses in these locations. If you use the 40A
fuse, obtain another from your dealer or from an automobile parts
store, and replace the spare fuse in the electrical box cover. If the
system continues to blow fuses, take the boat to your dealer and
have the electrical system checked.
INDM-0017
Figure 7.14 – Fuse Box Layout
Fuses are located on top of the engine near the intake. To remove
or inspect a fuse, remove molded plastic cap from fuse holder.
Inspect fuse and replace if it is defective. Make sure to replace
the fuse block cover when finished for the fuse block to be
ignition protected.
To Next Page
Loading...
Need help?
General