5-2
SECTION FIVE
2. Perform the Pre-Start Checks. Refer to Section 3.
3. Move the shift control lever to the NEUTRAL position. Pull out
the neutral safety lever (if equipped). Without advancing the
throttle lever, turn the starter key to START position.
NOTICE
The throttle should be in the neutral position with the neutral
detent button on the shift control box pulled out.
NOTICE
Refer to the boat owner’s manual for ignition system information.
4. When the engine starts
to crank, you can release
the key and let Smart Start
take over. When the engine
starts, it will gradually slow
from a fast idle to normal
idle. If engine is cold, it will
operate at a slightly higher
idle speed until warm-up is
complete. Make sure that
when you do shift into gear
that you are at idle speed
(less than 1100 RPM). Let
engine warm up to normal
operating temperature
before accelerating.
ON
START
OFF
ACC
INDM-A012
Figure 5.2 – Start Position
To Next Page
Loading...
