Indutherm MC60V - Error Diagnosis; Troubleshooting; Service

Operation
sales@romanoff.com | www.romanoff.com
2019-01-08
7–4
pressure) to overpressure (casting pressure) inside the chamber.
The generator stops heating. On the display “Time” a timer counts
the seconds after casting.
> After a sufficient waiting time, unlock the handle and tilt the unit
back to horizontal position. The casting pressure inside the cruci-
ble chamber is released through “Gas Out” to ambient pressure.
> Open the casting chamber and remove flask and flask holder.
Attention!
You have to activate the melting pressure by pressing “Start”-
button after the washing cycles.
7.4 Error diagnosis
There two types of trouble.
 Error and
 Warnings.
If an error occur the heating will be switched off and you’ll see error
code in display.
With a light fault a warning appear in display. You’ll see the warning
code in display.
7.5 Troubleshooting
Only an expert may open the system.
Trouble
Cause
Machine can’t
be switched on.
 Missing mains supply.
Heating don’t
work
 Cooling water supply not switched on („E010”).
 Protective gas supply not switched on („E013“).
 Thermocouple not put in or faulty („0FbE“).
 Generator overheated (too hot, „E021“).
 Another error („Exxx“).
 Exhibition mode activated (P.155 = 0?).
Temperature
indication not
right
 Wrong thermocouple programmed, see software doc-
umentation.
 Thermocouple faulty.
Because of that the generator can stop heating!
Low generator
output
 Set-value of temperature too low.
Additional error messages see software-documentation.
7.6 Service
If you need technical support from company INDUTHERM
Erwärmungsanlagen GmbH, we’d like to have following information
with first contact:
 Service No. M19999 DM on the left front side of machine or
 Service No. from nameplate at backside of machine.