Inficon CDG025D2 - Device Reset Command; Exception Reset Command

58 tirb45e1 (2019-02) CDGxxxDxx.cp
Response
Byte 0
See Subindex 0x02
Byte 1
Unused
Byte 2 0: Full Scale Adjust successful
1: Full Scale Adjust failed: out-of-range
254: No previous Full Scale Adjust command issued
Execution of this command causes the device to emulate a complete power cycle.
This includes an ESC reset.
As consequence of an ESC reset all following devices are disconnected
from the network.
There are two versions of this command:
• Standard reset (as described above)
• Factory reset (as described above, but additionally, all parameters are restored
to as-shipped defaults).
Index
SI
DataType
NV
Access
PM
Name
FBF0
0x01
V_STRING(6)
RW
Command
0x02
BYTE
RO
Status
0x03
V_STRING(2)
RO
Response
A device reset is initiated when the following byte sequence is sent.
Command
Byte 0
Byte 1
Byte 2
Byte 3
Byte 4
Byte 5
0x74
0x65
0x73
0x65
0x72
0x00 = Standard reset, 0x66 = Factory Reset
Status (supported values)
0
1
2
3
255
Reserved
Reserved
Last command completed, error, no response
Reserved
Command is executing
Response
Byte 0
See Subindex 0x02
Byte 1
not used = 0x00
Execution of this command clears the latched exceptions.
Index
SI
DataType
NV
Access
PM
Name
FBF1
0x01
V_STRING(5)
RW
Command
0x02
BYTE
RO
Status
0x03
V_STRING(2)
RO
Response
Subindex 0x03
5.8.4 Device Reset Command
Subindex 0x01
Subindex 0x02
Subindex 0x03
5.8.5 Exception Reset
Command