tina96e1-b (2016-12) VGC501_VGC502_VGC503.om 107
Connect the VGC50x to a computer …
• with a crossover Ethernet cable,
• via a switch, or
• with an Ethernet patch cable (precondition: the interface is auto MDI-X
capable).
The DHCP server assigns automatically an IP address.
Precondition: DHCP = ON (standard)
Search for the VGC50x in the network using the Ethernet Configuration Tool
and assign it to a virtual COM interface (→ 107).
Start the program for communication with the VGC50x and connect it to the
assigned COM interface.
Save all VGC50x parameters on a USB memory stick ("SAVE SETUP",
→ 63).
Set the following Ethernet parameters in the saved CSV file on the memory
stick:
IP ADDRESS: 192.168.0.1 (192.168.0.2 for a second unit, and so on)
NETMASK: 255.255.0.0
DHCP: OFF
Load the modified parameters onto the VGC50x ("RESTORE SETUP",
→ 63).
Connect the VGC50x to a computer …
• with a crossover Ethernet cable,
• via a switch, or
• with an Ethernet patch cable (precondition: the interface is auto MDI-X
capable).
Search for the VGC50x in the network using the Ethernet Configuration Tool
and assign it to a virtual COM interface (→ 107).
Start the program for communication with the VGC50x and connect it to the
assigned COM interface.
With the Ethernet Configuration Tool a virtual serial interface (COM) can be as-
signed to an IP address. In addition, it allows configuration of the Ethernet interface
via a computer.
Precondition: Windows 7, 8 or 10 operating system (does not work under
Windows XP)
C 2: Connect the VGC50x to a
Computer
Computer with DHCP server
Computer without DHCP
server
C 3: Ethernet Configuration
Tool
To Next Page
Loading...