50 tina96e1-b (2016-12) VGC501_VGC502_VGC503.om
GENERAL >I The General parameters group is used for displaying,
entering and editing generally applicable system para-
meters.
UNIT I Measurement unit
BAUD USB I Transmission rate USB interface
RNG-EXT I Pirani range extension
AO-MODE I Recorder output
ERR-RELAY I Error relay
BARGRAPH I Bar graph display
BACKLIGHT I Backlight
SCREENSAVE I Screensaver
CONTRAST I Contrast adjustment
DEFAULT I Factory settings
LANGUAGE I Language
FORMAT I Number format, measurement value
END VAL I Display of measurement range end value
< I One level back
Unit of measured values, thresholds etc. (conversion table → 102).
Value
UNIT I
UNIT MBAR I mBar
UNIT HPASCAL I hPa (factory setting)
UNIT TORR I Torr (only available if Torr lock is not
activated → 59)
UNIT PASCAL I Pa
UNIT MICRON I Micron (= 0.001 Torr) (only available if Torr
lock is not activated → 59)
UNIT VOLT I V
A change of the pressure unit influences also the pressure unit settings of the BPG,
HPG and BCG gauges.
VGC501 only: If the measurement unit micron is selected, automatic changeover to
Torr occurs above 99000 micron. Below 90 Torr automatic changeover back to the
measurement unit micron occurs.
4.5.4 General Parameters
Parameters in this group
Measurement unit
To Next Page
Loading...
