tina96e1-b (2016-12) VGC501_VGC502_VGC503.om 63
SETUP >I This group is used for
• saving all parameters on a USB memory stick
(interface type A on the front of the VGC50x)
• loading all parameters from a USB memory stick
onto the VGC50x
• formatting a USB memory stick
• deleting files with saved parameters from the USB
memory stick
This group is only available when a USB memory stick formatted for the
FAT file system (FAT32) is plugged in. Use a max. 32 GB memory stick.
SAVE I Saving all parameters
RESTORE I Loading all parameters onto the VGC50x
FORMAT I Formatting USB memory stick (FAT32)
CLEAR I Deletion of files with saved parameters
< I One level back
Saving all parameters of the VGC50x to a USB memory stick (file ending: CSV).
The setpoint/threshold and offset values are stored in mBar or hPa,
respectively.
Value
SAVE I
SAVE SETUP I File name on the USB memory stick:
SETUP01.CSV
…
SAVE SETUP99 I File name on the USB memory stick:
SETUP99.CSV
SAVE RUNNING I CSV file is being saved
SAVE DONE I Saving completed
4.5.7 Parameter Transfer Mode
Parameters in this group
Saving a parameter
To Next Page
Loading...
