EasyManua.ls Logo

InfiNet Wireless R5000 - Other Topologies Configuration

InfiNet Wireless R5000
32 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
InfiNet Wireless Quick Start Guide
Copyright © 2004-2009 by InfiNet Wireless Limited.
26
IV. Other topologies configuration
The configuration in Point-to-Multipoint node is very much similar to the one in
Point-to-Point mode. Same parameters (RF, MINT) should be configured (in the
simplest case). For the Base Station unit, the type of the node (in MINT
command) should be specified as master. For CPEs type slave should be
used.
For MESH network configuration, type mesh should be used. Many other
parameters can be configured to fine-tune mesh network (node mode, costs
parameters etc).

Other manuals for InfiNet Wireless R5000