InfiNet Wireless Quick Start Guide
Copyright © 2004-2009 by InfiNet Wireless Limited.
Accessing the unit via Ethernet
If your PC/Laptop does not have a COM-port or you want to plug the unit to the
LAN switch you can configure it using Telnet protocol.
The default IP-address assigned to the eth0 interface of the unit is 10.10.10.1
with 255.255.255.0 mask.
If you connect the unit directly to the LAN/PC/Laptop you should either change
the IP-address on the Ethernet adaptor or create an alias IP-address which
would be located in 10.10.10.0/24 network.
Connect the unit to LAN/PC/Laptop using UTP cable with RJ-45 connectors.
The procedure is the following:
1. Open the Control Panel in Windows. See Figure 10
Figure 10. Open Control Panel
2. Open “Network connections” icon. See Figure 11
Figure 11. “Network connections”
3. In “Network connections” folder right mouse button click on the LAN
connection and click “Properties”. See Figure 12
To Next Page
Loading...
