InfiNet Wireless Quick Start Guide
Copyright © 2004-2009 by InfiNet Wireless Limited.
Figure 3. Screw Lock ODU Front (fragment)
Accessing the unit via Console
If you cannot get access to the unit using procedure described in “Accessing the
unit via Ethernet” section please follow the steps described in this section.
1. Using InfiNet Console Cable please connect the unit’s console port (see Fig.
2) to the COM-port of your PC/Laptop
In order to accomplish the steps described in this section your
PC/Laptop must be equipped with a COM-port
2. Locate the power cord in the package
3. Plug the power cord into the IDU power supply connector and to the power
supply socket (220V 50 Hz or 110V 60 Hz depending on the country of
residence)
4. Green power indicator on the IDU must light up
5. Power your PC/Laptop on
Following step’s screenshots are taken from Microsoft Windows XP.
You can also perform this procedure in Microsoft Windows
98/NT/2003
6. Run Hyperterminal. See Figure 4
Figure 4. Locate Hyperterminal
7. Indicate connection name (e.g. “IWR Lab Test”) and specify the COM-port
name to which the unit is connected. See Figure 5
To Next Page
Loading...
Need help?
General
