InFocus IN1110 - Using the Audio; Troubleshooting Audio

18
Using the remote control
The remote uses two (2) AA batteries. They are easily installed by removing the
cover from the remote’s back, aligning the + and - ends of the batteries, sliding them
into place, and then replacing the cover.
Caution:
• When disposing of the batteries, be sure to do so in an en
vironmentally proper
manner
.
• If the remote control gets wet, wipe it dry immediately.
• Avoid excessive heat and humidity.
• Ensure the batteries' polarity (+/-) is aligned correctly.
• Do not mix new and old batteries together
, or dif
ferent types of batteries
together.
• Replace the batteries as soon as they run out.
• Remove batteries from the remote control when storing
or not in use for a
prolonged period.
To operate, point the remote at the front of t
h
e projector (not at the computer). The
range of optimum operation is about 30 feet (9 m).
Press the remote’s Power button
to turn the projector on and off (see page 10 for
shutdown info).
Press the remote’s Menu button to open the projector’s menu system. Use the arrow
buttons to navigate, and the Select button to select features and adjust values in the
menus. See page 23 for more info on the menus.
The remote also has:
• Volume
buttons to adjust the sound.
• Custom button that can be assigned to a special function
, like Blank Screen or
Freeze (see page 25).
• Sour
ce b
utton to switch between sources.
• Blank button to blank the screen.
• Presets button to select stored settings (see page 24).
• Mute button to silence the audio.
• Auto Image
button to resynchronize the projector to the source.
• Resize button to switch among aspect ratios (see page 29).
• Help
button to provide interactive help for solving common, picture, sound,
and cabling problems.
Troubleshooting the remote
• Make sure the batteries are installed in the proper orientation
and are not dead.
• Make sure you’re pointing the remote at the projector or the
screen, not the
computer, and are within the remote range of 30 feet (9 m). For best results,
point the remote at the projector.
navigation
buttons