InFocus IN2102 User Manual

11
Adjusting the image
If necessary, adjust the height of the projector by pressing the elevator foot
release button to extend the foot.
If necessary, rotate the leveling foot located at the rear of the projector.
Avoid placing your hands near the hot exhaust vent at the side of the projec-
tor.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen.
See page 5 for a table listing screen sizes and distances.
Adjust the zoom or focus.
If the image is not square, first make sure that the projector is perpendicular
to the screen. If the image is larger or smaller on the top or bottom edge of
the screen, press the top Keystone button to reduce the upper part of the
image, and press the bottom Keystone button to reduce the lower part.
If the left or right side of the screen is larger or smaller the other, you can
turn the projector to the left or to the right a few degrees to square the
image.
Adjust the Contrast or Brightness in the Basic Picture menu. See page 28 for
help with these menu adjustments.
For Aspect Ratio, keep in mind that DVD players must be configured for
16:9 in order to view the highest quality image. For more information
regarding Aspect Ratio, see
page 12.
adjust height
elevator
foot
release button
adjust distance
adjust zoom or focus
focus
(front ring)
(rear ring)
zoom
adjust keystone
adjust Basic Picture menu

InFocus IN2102 Specifications

General

Matrix size	0.55 \
Projection distance	10 m
Vertical scan range	50 - 85 Hz
Horizontal scan range	31 - 79 kHz
Projection technology	DLP
Contrast ratio (typical)	2000:1
Projector native resolution	SVGA (800x600)
Keystone correction, vertical	-20 - 20 °
Aspect ratio	4:3, 5:4, 16:9
RS-232 ports	1
Dimensions (WxDxH)	297.2 x 228.6 x 99.1 mm
Power requirements	100 - 240, 50 - 60 Hz
Connectivity technology	Wired
Lamp power	200 W
Light source type	Lamp
Service life of light source	2500 h
Service life of light source (economic mode)	3000 h
Analog signal format system	NTSC, PAL, SECAM
RMS rated power	2 W
Microphone in	Yes
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Component video (YPbPr/YCbCr) in	2
Noise level	35 dB
Certification	UL, c-UL, FCC-A, CE, GOST, TUV GS, CCC, IRAM, NOM, C-Tick, MIC, eK, PSB
Power consumption (typical)	250 W
Operating temperature (T-T)	5 - 31.11 °C

Weight and Dimensions

Weight	3130 g
Package weight	5260 g