27
Contrast
The contrast controls the degree of difference between the light-
est and darkest parts of the picture. Adjusting the contrast
changes the amount of black and white in the image.
1 Use the up and down arrows to highlight Contrast, press
menu/select
, use the arrows to adjust the contrast, then press
menu/select
to accept your changes.
Tint
NOTE: The color setting applies
to video sources only. The tint set-
ting applies to NTSC video sources
only.
The tint adjusts the red-green color balance in the projected
image.
1 Use the up and down arrows to highlight Tint, press
menu/select
, use the arrows to adjust the tint, then press
menu/select
to accept your changes.
Color
The color setting adjusts a video image from black and white to
fully saturated color.
1 Use the up and down arrows to highlight Color, press
menu/select
, use the arrows to adjust the color, then press
menu/select
to accept your changes.
Sharpness
This setting adjusts sharpness of a video image.
1 Use the up and down arrows to highlight Sharpness, press
menu/select
, use the arrows to cycle through the options soft,
med-soft, medium, med-hard, and hard, then press
menu/
select
to accept your selection.
Blank screen
Blank Screen determines what color is displayed when there is no
active source and when the projector is in standby.
1 Use the up and down arrows to highlight Blank screen, press
menu/select
, use the arrows to cycle through the options blue,
black, and white, then press
menu/select
to accept your selec-
tion.
To Next Page
Loading...
