InFocus X6 - Page 11

10
English ...
Introduction
5 Keystone
Correction
Adjust the image to compensate
for distortion caused by tilt-
ing the projector (vertical ± 15
degrees).
6 Source Press“source”tochooseRGB,
Component,S-Video,Composite
and HDTV sources.
7 Menu Press “menu” to launch the On-
screendisplay(OSD)menu,back
to the top level of OSD menu for
the OSD main menu operation
8 AV-Mute Momentarily turn off/on the
audio and video.
9 Reset Change the adjustments and set-
tings to the factory default
value.
10 Video 1 Source
(S-Video)
Press “video 1” to choose video 1
connector.
11 Video 2 Source
(Composite)
Press “video 2” to choose video 2
connector.
12 Digital Zoom Zoom the projector display in or
out.
13 Enter Conrmyoursectionofitemsin
sub menu operation.
14 Re-Sync Automatically synchronize the
projector to the input source.
15 Four
Directional
SelectKeys
Useup,down,left,rightsto
select items or make adjustments
to your selection.
16 Source Lock Press “source-lock” to lock speci-
edconnectionport;pressthis
again to unlock.
17 Volume-/+ Increase/decrease speaker vol-
ume.