InFocus X6 - Page 31

30
English ...
Appendices
Problem: Image has vertical ickering bar

Use “Frequence” to make an adjustment.

Checkandrecongurethedisplaymodeofyourgraphiccardto
make it compatible with the product.
Problem: Image is out of focus

Adjust the Focus Ring on the projector lens.

Make sure the projection screen is between the required distance
3.9to39.4feet(1.2to12.0meters)fromtheprojector(refertopage
16).
Problem: The image is stretched when displaying 16:9 DVD
Theprojectorautomaticallydetects16:9DVDandadjuststheaspect
ratio by digitizing to full screen with 4:3 default setting.
Iftheimageisstillstretched,youwillalsoneedtoadjusttheaspect
ratio by referring to the following:

Please select 4:3 aspect ratio type on your DVD player if you are
playinga16:9DVD.

Ifyoucan’tselect4:3aspectratiotypeonyourDVDplayer,
please select 4:3 aspect ratio in the on screen menu.
Problem: Image is reversed

Select “Display Setting-->Projection” from the OSD and adjust the
projection direction.
Problem: Lamp burns out or makes a popping sound

Whenthelampreachesitsendoflife,itwillburnoutandmay
makealoudpoppingsound.Ifthishappens,theprojectorwill
not turn on until the lamp module has been replaced. To replace
thelamp,followtheproceduresinthe“ReplacingtheLamp”.