130
5. Remove four retention screws (two on each side). The screws secure the hard
drive to the drive tray.
2.5 inch SAS HDD (without MUX)
2.5 inch SATA HDD (with MUX)
MUX board screw locations
2.5 inch SAS hard drive
2.5 inch SATA hard drive
6. Replace the drive. After swapping the drive, fasten the retention screws back.
Refer to screw locations in the previous step.
7. Insert the drive tray back into the enclosure. Install the drive tray with the
front bezel open. When fully inserted, close the front bezel.
To Next Page
Loading...
