Slide Rail Installation Guide
139
Unpacking the System
Use the “Unpacking List” to cross check all components have been received. The
basic contents include one GUI CD pack, Quick Installation Guide and Enclosure
Installation Guide. For details on each slide rail kit contents, please refer to specific
kit installation details in this manual.
Component Installation Procedure
Please install components in the following order:
1. Rackmount rails onto the enclosure / rack / cabinet
2. Enclosure onto the slide rail and into the cabinet
3. Hard drives into drive trays and then into the enclosure.
4. Drive trays (with or without hard drives) into the enclosure
5. If Super Capacitor battery / FBM were purchased as an optional component, the
controller must be removed from the enclosure for installation.
NOTE
For detail procedures from step 3 and onwards, please refer to the earlier sections in
this hardware manual.
Tools Required
For each of the slide rail installation procedures, you will need the following tools:
One medium sized Phillips screwdriver
One small sized Phillips screwdriver
One medium size flat blade screwdriver
To Next Page
Loading...
