ESD Precautions
ESD Precautions
Handle the modules by their retention screws, ejector levers, or the module’s metal
frame/faceplate only. Avoid touching the PCB boards or connector pins.
Use a grounded wrist strap and an anti-static work pad to discharge static electricity
when installing or operating the enclosure.
Avoid dust, debris, carpets, plastic, vinyl, and styrofoam in your work area.
Do not remove any module or component from its anti-static bag before installation
takes place.
Drives must not be stacked on top of each other without their protective drive trays.
Even when drives are fixed in the drive trays, contacting the exposed PCB or
rear-side interface may damage the drives.
To Next Page
Loading...
