Infortrend S12 Series - Page 105

EonStor / EonStor DS S12/S16/S24 Series
JBO
Ds and Corresponding RAID Systems
RAID Models 2U JBOD 3U JBOD Configuration
S12F-S2840N
S12S-J2000SN X
S12E-G1xxx
S12S-J1000-G S16S-J1000-S1
S12x-G2xxx
S12S-J2000-G X
S16E-G1xxx
S24F-G1xxx
X
S16S-J1000-S /
S16S-J1000-S1
S16x-G2xxx
S24x-G2xxx
X S16S-J2000-S
Single-controller; single path
S12F-R2840N
S12S-J2000RN X
S12x-R1xxx
S12S-J1002-R S16S-J1000-R1
S12x-R2xxx
S12S-J2000-R X
S16F-R1xxx
S24F-R1xxx
X
S16S-J1000-R /
S16S-J1000-R1
S16x-R2xxx
X S16S-J2000-
R
Dual-controller; fault-tolerant paths
S24x-R2xxx
There is a rotary ID switch on every
expansion enclosure that is manually
configured using a flat blade screwdriver.
Configuring enclosure IDs:
 The configurable IDs for JBODs are
from 1 to 15. Usually the numbering
m the one closest to the managing RAID enclosure.
es can be properly assigned. RAID system firmware
automatically manages these addresses.
starts fro
 Make sure a unique ID is configured on each JBOD so that the SAS WWN
addresses of disk driv
105