EonStor / EonStor DS S12/S16/S24 Series
There is a
rotary ID switch on every
expansion enclosure that is manually
configured using a flat blade screwdriver.
Configuring enclosure IDs:
The configurable IDs for JBODs are
from 1 to 15. Usually the numbering
starts from the one closest to the
managing RAID enclosure.
Make sure a unique ID is configured on each JBOD according to the table
so
that the SAS WWN addresses of disk drives can be properly assigned. RAID
system firmware automatically manages these addresses.
Type II Expansion connection
RAID System
RAID System
3U JBOD
D
.
.
.
JBOD
3U JBO
.
.
.
.
.
.
.
4U48
3U JBOD
3U JBOD
.
.
.
.
.
.
.
4U48 JBOD
.
.
.
Si er systems D sy
For 4
U S48 JBODs, please refer to at system for
con d setup tails.
ngle controll ual controller stems
the manual th came with the
figuration an de
108
To Next Page
Loading...
