EasyManuals Logo

INFOSEC UPS SYSTEM E4 Evolution II TT Series User Manual

INFOSEC UPS SYSTEM E4 Evolution II TT Series
Go to English
141 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #114 background imageLoading...
Page #114 background image
113
INFOSEC UPS SYSTEM 15, Rue du Moulin 44880 Sautron France www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 fax : +33(0)2 40 94 29 51 hotline@infosec.fr 02 19 AA 59 203 07
Fault! Over Load Fault
Heavy overload causes UPS fault.
Fault! Battery Fault
Batteries reversed
Fault! Over Temperature
Make sure adequate space is allowed for air ventilation and
the fan is working
Fault! CAN Fault
CAN communication fault
Fault! TRIG0 Fault
Synchronized trigger signal fault
Fault! Relay Fault
Inverter relay fault
Fault! Line SCR Fail
Line SCR short circuit fault
Fault! EEPROM Fault
EEPROM operation error
Fault! Parallel Cable Loosen Fault
As stated.
Fault! DSP MCU Stop Communicate
As stated.
Fault! Bypass Temperature Fault
As stated
Fault! Bypass SCR Fault
As stated.
Line Fail
Utility lost or abnormal
Line Restore
Utility recovered to normal
Warning! EPO Active
Check the EPO connector
Warning! Over Load Fail
The load devices are demanding more power than the UPS
can supply. Line mode will transfer to Bypass mode.
Warning! Communicate CAN Fail
CAN communication error
Warning! Over Load
In Line mode, the load devices are demanding more power
than the UPS can supply.
Warning! Battery Open
Battery not connected
Warning! Battery voltage High
Battery voltage is too high
Warning! Turn On Abnormal
As stated.
Warning! Charge Fail
As stated.
Warning! EEPROM Fail
EEPROM operation error
Warning! Fan Lock
As stated.
Warning! Line Phase Error
As stated.
Warning! Bypass Phase Error
As stated.
Warning! N Loss
Neutral loss
Warning! Internal Initial Fail
As stated.
Warning! Comm Syn Signal Fail
Communicate synchronization signal fail
Warning! Comm. TRIG0 Fail
Communicate trigger signal fault
Warning! Power Stage loss
Power stage is not detected.
Warning! Parallel Sys Config. Wrong
Parallel system configuration error
Warning! Maintenance Bypass
Enter maintenance bypass status
Warning! Battery Age Alert
Battery life expiration
Warning! Parallel UPS Cable Loosen
As stated.
Warning! Parallel UPS Config. Wrong
Parallel UPS configuration error

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the INFOSEC UPS SYSTEM E4 Evolution II TT Series and is the answer not in the manual?

INFOSEC UPS SYSTEM E4 Evolution II TT Series Specifications

General IconGeneral
BrandINFOSEC UPS SYSTEM
ModelE4 Evolution II TT Series
CategoryUPS
LanguageEnglish

Related product manuals