Need help?Do you have a question about the INNO VIEW 5 and is the answer not in the manual?
General| Typical Splice Loss SM | 0.02dB |
|---|---|
| Typical Splice Loss MM | 0.01dB |
| Typical Splice Loss DS | 0.04dB |
| Splicing Method | Core Alignment |
| Data Output | USB |
| Dimensions | 180 x 150 x 100 mm |
| Applicable Fibers | SM, MM, DS, NZDS |
| Fiber Count | Single |
| Cladding Diameter | 80 ~ 150µm |
| Coating Diameter | 100 ~ 1000µm |
| Return Loss | ≥60 dB |
| Display | 5" LCD |
| Operating Altitude | 0-5000 m |
| Operating Temperature | -10 ~ 50°C |
| Operating Humidity | 0-95% RH |
| Storage Humidity | 0-95% RH |
Details compatible optical fiber types and specifications for the splicer.
Specifies splice loss standards and available splice modes.
Covers power voltage requirements and essential battery handling safety guidelines.
Critical safety rules and general precautions for operating the fusion splicer.
Introduces the splicer's main parts, display, and connectivity ports for setup.
Guides on handling, charging, and refreshing the battery pack for optimal performance.
Guides on turning on, adjusting monitor, preparing and cleaving fibers for splicing.
Explains the splicing steps, protection of the splice, and the heating procedure.
Covers selecting and configuring splice programs and heater modes for optimal results.
Details electrode replacement, stabilization, diagnostic tests, and software updates.
Provides solutions for common causes of high splice loss and related issues.
Lists common error messages and provides precise solutions for resolving them.
To Next Page