NV9 USB Manual Set – Section 1 10
Copyright © Innovative Technology Ltd 2012 GA00550-2
To use a USB connection with the NV9 USB, a USB cable fitted with a 16 way
connector on one end (ITL Part Number CN00392) should be used. The CN00392
cable fits into the 16 way connector and allows high speed programming and serial
communications when used in SSP, ccTalk and SIO modes.
When using the USB connection, power must be supplied to the NV9 USB using the
CN00392 cable.
1.6 Programming
Full details on programming the NV9 USB Validator can be found in Section 3 of this
manual set (ITL Software Support Guide).
To Next Page
Loading...
