- 139 -
3
STOP key stop and fault reset
function enabled in the terminal
control mode
QUICK parameter lockout
Factory default
value
0
QUICK parameter lockout inenabled. The
parameter items in the shortcut menu can be
added, reduced or modified at this time.
F7-03
Setup
range
1: QUICK parameter lockout inenabled. The
parameter items in the shortcut menu cannot
be modified at this time, but the related
parameter contents can be modified.
LED operation display
parameter
Factory default
value
624
F7-04
Setup
range：
1~ 65535
If the above parameters need to be displayed
during the operation, set the corresponding
positions to 1, and change the binary numbers
into decimal numbers and set them in F7-01.
To Next Page
Loading...
