- 155 -
Motor
specifications
solidification
Factory
default value
0
FP-02
setup
instroution
When the motor specifications solidification parameter is non-zero, the
following parameters will not be able to change:
F1-00： Motor type selection
F1-01：Rated power
F1-02：Rated voltage
F1-03：Rated current
F1-04： Rated Frequency
F1-05：Rated rotation speed
F1-15：Back EMF
FP-03： Injection molding machine specifications solidification
Commissioning introduction:
It can not only realize motor specifications solidification,but also set the “ motor
static tuning ” (F1-16 = ” “ 1) and “ AI zero drift auto correction” (A3-20 = “ 0 ”),
after that,injection molding machine is able to realize running.Then adjust
PID, and the injection molding machine parameter adjustment is ended.
Injection molding
machine
specifications
solidification
Factory
default value
0
FP-03
setup
instroution
When the parameter of injection molding machine specifications solidification
is non-zero, the following parameters can not be changed.
F1-00： Motor type selection
F1-01： Rated power
F1-02： Rated voltage
F1-03： Rated current
F1-04： Rated Frequentcy
F1-05： Rated rotation speed
F1-15： Back EMF
F2-00： Speed loop proportional gain 1
1 05 17
Motor manufacturer
number
Motor rated torque
divided by 10
Motor rated rotation
speed divided by
100
01 012
Injection molding machine
manufacturer number
Injection molding
machine divided by 10
To Next Page
Loading...
