- 34 -
3.2.3 Connections of servo pump
Schematic Diagram for Servo Pump Connections
3.2.4 Main Circuit Terminals and Connections
z Make sure that the power switch is in OFF status prior to perform wiring
connection. Otherwise there may be danger of electric shock!
z
z Only the qualified and trained personnel can perform wiring connection.
Otherwise it may cause equipment and human injuries!
z It shall be earthed reliably. Otherwise there may be danger of electric
shock or fire!
z Make sure that the rated value of the input power supply is consistent
with that of the driver. Otherwise it may damage the driver!
z Make sure that the motor matches the driver. Otherwise it may damage
the motor or generate driver protection!
z Do not connect the power supply to the terminals of U, V and W.
Otherwise it may damage the driver!
z Do not directly connect the brake resistor between the DC bus terminals
(+) and (-). Otherwise it may cause fire!
To Next Page
Loading...
