Inovance MD380L - Page 23

20
CONTINUE
Para.
Parameter name Default
Commissioning
Set S-curve
F6-
07
Acceleration/Deceleration mode 3 3
0 : Linear acceleration/ deceleration
3: S-curve acceleration/ deceleration C
F6-
08
Time proportion of S-curve at Accel start 80.0 80.0
0.0% to Min[(100.0% - F6-09), 80%]
F6-
09
Time proportion of S-curve at Accel end 10.0 10.0
0.0% to Min[(100.0% - F6-08), 80%]
F6-
26
Time proportion of S-curve at Decel start 20.0 20.0
0.0% to Min[(100.0% - F6-27), 80%]
F6-
27
Time proportion of S-curve at Decel end 30.0 30.0
0.0% to Min[(100.0% - F6-26), 80%]
Set DC injection for stopping
F6-
11
DC injection 2 frequency threshold 0.50 0.50
0.00 Hz to maximum frequency
F6-
12
DC Injection 2 delay ON set time 0.0 0.0
0.0 to 36.0 Sec
F6-
13
DC injection 2 level 30 30
0 to 100 Hz
F6-
14
DC injection 2 active set time 0.5 0.5
0.0 to 36.0 Sec
Set VF parameters
F3-
00
V/F curve selection 0 0
if it is VF control
0: Linear V/F
1: Multi-point V/F
SETTING RANGE: 0 to 11;
F3-
01
Torque boost 0.0 0.0
0.0 to 30.0 %;
NOTE: if it is 0, then auto torque boost is activated, and it is recommended to use auto torque boost.
Set SVC parameters
F2-
00
Speed loop proportional gain 1 10 10
0 to 100.
F2-
01
Speed loop integral time 1 0.5 0.5
0.01 to 10.00 Sec.
F2-
02
Switchover frequency 1 3.00 3.00
0.00 to F2-05
F2-
03
Speed loop proportional gain 2 30 30
0 to 100.
F2-
04
Speed loop integral time 2 0.5 0.5
0.01 to 10.00 Sec.
F2-
05
Switchover frequency 2 7.00 7.00
F2-02 to maximum output frequency
OVER