Inovance MD500-PLUS Series - Extension Cards; List of Extension Cards

Extension Cards
‑129‑
6 Extension Cards
6.1 List of Extension Cards
The AC drive supports multiple types of extension cards and encoders for
communication with the fieldbus as well as programming and secondary
development.
Table 6–1 List of extension cards
Card Model Function Remarks
I/O extension card 1
MD38IO1
Adds five DIs, one RO, and one DO, with
Modbus/CANlink.
Available for T4 models and
above
I/O extension card 2
MD38IO2 Adds three DIs. Available for all models
I/O extension card 3
MD38IO3
Adds three DIs, one RS485 communication
signal isolation input, and one normally open
relay output.
Available for all models
RS485 communication
card
MD38TX1
Modbus communication adapter card with
isolation
Available for all models
CANlink
communication
extension card
MD38CAN1
CANlink communication adapter card
Available for all models
CANopen
communication
extension card
MD38CAN2
CANopen communication adapter card
Available for all models
PROFIBUS‑DP
communication card
MD‑SI‑DP PROFIBUS‑DP communication card T1 to T3
PROFIBUS‑DP
communication card
MD38DP2 PROFIBUS‑DP communication card T4 to T13
PROFINET
communication
extension card
MD500‑PN1
PROFINET communication adapter card
Available for all models
EtherCAT
communication
extension card
MD500‑ECAT
EtherCAT communication adapter card
Available for all models
Ethernet/IP
communication
extension card
MD500‑EN1
Ethernet/IP communication adapter card
Available for all models
Resolver interface card MD38PG4
Applicable to resolvers, with DB9 interface,
excitation frequency: 10 kHz;
To meet the MD38PG4 requirements, the
excitation input DC resistance of the resolver
must be greater than 17 Ω. Failure to comply
may result in malfunction of MD38PG4. Use
resolvers with no more than four pole pairs.
Failure to comply may result in overload of
MD38PG4.
Available for all models