Compliance
‑168‑
● The integrator who integrates this product into other products and attaches CE
mark to the final assembly has the responsibility of ensuring compliance with CE
certification.
9.2.2 Conditions for Compliance with the EMC Directive
● This product satisfies the European EMC directive 2014/30/EU and the EN 61800‑3
standard, and is applicable to both the first environment and the second
environment.
When applied in the first environment, this product may generate radio interference. In ad‑
dition to the CE compliance requirements described in this chapter, take measures to avoid
radio interference if otherwise required.
● To satisfy the EMC directive and standard, install an EMC filter on the input side of
the product, use a recommended shielded cable on the output side, ground the
filter reliably, and ensure the shield of the output cable is grounded 360 degrees.
Manufacturers of systems integrating with this product are responsible for system compli‑
ance with the European EMC directive and EN IEC 61800‑3 requirements in different system
application environments.
EMC Specifications
Observe the product requirements during installation. This product meets the
requirements of the EN IEC 61800‑3 standard. Limit the motor cable length in
accordance with the following table to avoid impact of conducted and radiated
disturbance.
To Next Page
Loading...
