Compliance
‑170‑
9.2.3 Conditions for Compliance with the LVD
This product has been tested according to EN61800‑5‑1, and it complies with the Low
Voltage Directive (LVD) completely. To enable machines and devices integrating this
product to comply with the LVD, the following requirements must be met.
Installation location
Install this product in a place with the pollution degree of 2 or below and overvoltage
category III as specified in IEC 60664‑1.
Installation environment
For requirements of installation environment, see "Installation Environment" in
MD500‑PLUS Series General‑Purpose AC Drive Installation Guide
.
Requirements on installation and protection
● This product must be installed in a cabinet with the fire‑proof housing that
provides effective electrical and mechanical protection. The installation must
conform to local laws and regulations and related IEC requirements..
● For a cabinet‑mounted AC drive (IP20), install it in structures that cannot be
accessed by foreign objects from the top and front.
Main circuit wiring requirements
For wiring requirements of main circuit terminals, see "Main Circuit Wiring
Requirements" in
MD500‑PLUS Series General‑Purpose AC Drive Installation Guide
.
Requirements on protective devices
To meet the requirements of EN 61800‑5‑1, install a fuse/circuit breaker on the input
side to prevent accidents caused by internal short circuit. Use a fuse that matches the
maximum input value of the AC drive. For selection of fuses, see "
5.4.1 Fuse,
Contactor, and Circuit Breaker
"
on page 71
.
9.3 UL/cUL Certification
Figure 9‑2 UL/cUL mark
● The UL/cUL mark is usually attached to products distributed in US and Canada.
Products with the UL/cUL mark have been inspected and assessed by the UL
organization. For a product to receive UL certification, the main components
inside that product must also be UL certified.
To Next Page
Loading...
