Installation
‑61‑
Figure 5‑16 Top view of a cabinet for T11 and T12 models
To install a T11 or T12 model in a nine‑fold profile cabinet 600 mm in depth, fold
the back mounting plate inward, as shown in "
Figure 5–17
"
on page 61
, to borrow
the space of the column. (This requirement is not applicable to standard cabinets
greater than 800 mm in depth.) To install a T11 or T12 model in a cabinet with
access doors at both the front and the back, use a cabinet that is 800 mm in depth,
instead of a 600 mm one.
Figure 5‑17 Perspective view of a cabinet for T11 and T12 models
2. Fix the bottom mounting bracket in the nine‑fold profile cabinet.
Use six M5 self‑tapping screws to fix the mounting bracket onto the rack base of the
nine‑fold profile cabinet, as shown in "
Figure 5–18
"
on page 62
.
To Next Page
Loading...
