10
NS-HURSK18
www.insigniaproducts.com
Using the remote control
1 Remove the plastic tab from the battery compartment before using the
remote control for the first time.
2 Point the remote control directly at the IR sensor on the front of the
transmitter. You must be within approximately 23 ft. (7 m) of the
transmitter.
Programming a universal remote
If you want to use your Insignia TV remote to control the rear speaker kit,
you can program the rear speaker kit to take commands from your TV
remote.
Cautions
• Do not spill water or any liquid on the remote
control.
• Do not place the remote control on a wet
surface.
• Do not place the remote control in direct
sunlight or near sources of excessive heat.
• If the remote control is not going to be used for
a long time, remove the battery to avoid any
damage that may be caused by leakage and
corrosion.
NS-HURSK18_17-0639_MAN_V2_ENG.fm Page 10 Tuesday, August 1, 2017 11:48 PM
To Next Page
Loading...
