Insignia NS-HURSK18 - Setting up your speakers; Step 1 - Choosing your connection

11
Universal Rear Speaker Kit
www.insigniaproducts.com
1 Press and hold the + volume and - volume buttons on the transmitter for
three seconds to enter IR learning mode.
2 The optical and aux indicator LEDs blink slowly at the same time for 10
seconds.
3 Press + volume key on the transmitter to program.
4 The optical and aux indicator LEDs are solid on.
5 Press the + volume key on the TV remote.
6 Once a key is programed, The optical and aux indicator LEDs blink quickly
at the same time. Otherwise, the optical and aux indicator LEDs
alternately blink quickly.
7 To program the + volume and - volume buttons, repeat the steps shown
and replace steps 3 and 5 with the button you want to program.
Setting up your speakers
Step 1 - Choosing your connection
• Look at the back of your sound source device, such as a TV, DVD/Blu-ray
player, cable box, tablet, or mobile device to identify your audio OUT
ports. Choose the connection option below that fits your audio source.
You can connect several devices and switch the sound source as required.
Note
• If you wait longer than 10 seconds to begin programming,
the optical and aux indicator LEDS blink quickly alternately
and the transmitter will leave IR learning mode.
• Press and hold the (Power) and + volume buttons on
the transmitter to erase all IR learning data.
Caution
Turn off or unplug all devices while you are making connections.
AUDIO QUALITY JACK TYPE CABLE
Best
Good
Digital Optical cable (included). See “Digital
Optical connection (best)” on page 12.
3.5 mm to 3.5 mm cable (included). See “AUX
connection (good)” on page 12.
NS-HURSK18_17-0639_MAN_V2_ENG.fm Page 11 Tuesday, August 1, 2017 11:48 PM