18
NS-HURSK18
www.insigniaproducts.com
Using your speakers
This system lets you access two different sound sources: Optical or AUX.
Listening to your speakers
1 Press the
(Power) button on the transmitter or the remote control to
turn on your speaker system. The power indicator on the transmitter turns
off.
2 Turn on the audio source device connected to your speakers and begin
playback.
3 Press the
(source) button on the transmitter to select the audio source
or press the selected source button on the remote control until you hear
sound from your speakers.
4 Press and release the sound and pairing button on the back of the
transmitter or the Sound button on the remote control to switch between
stereo and surround sound modes.
5 Adjust the volume (master and rear speaker volume) on the transmitter,
on the remote control, or on the audio source device to a comfortable
level.
6 Adjust the sound delay on the remote control to synchronize the
soundbar with the rear surround speakers.
7 Press the
(Power) button again to turn off your speaker system. The
power indicator on the transmitter lights red.
Note
When you use the OPTICAL connection, the audio
content should be PCM or Dolby 5.1. Refer to the
manual you received with the output device for
additional information.
Note
• When you adjust the master volume, the rear/surround
speaker volume will be adjusted at the same time until you
reach the max or min volume.
• When you adjust the surround volume, the master/front
speaker volume will not be impacted.
Warning
Continuous use of high volume sound may
permanently damage your hearing.
NS-HURSK18_17-0639_MAN_V2_ENG.fm Page 18 Tuesday, August 1, 2017 11:48 PM
To Next Page
Loading...
