Integra DTR-20.7 - Page 73

Advanced Settings (Setup Menu)
En-41
Bluetooth
Setting Item Default Value Setting Details
Bluetooth On Select whether or not to use the Bluetooth
function�
"On": Enables connection with a Bluetooth-
enabled device by using the Bluetooth function�
Select "On" also when making various Bluetooth
settings�
"Off": When not using the Bluetooth function
Auto Input Change On The input of the unit will automatically be
switched to "BLUETOOTH" when connection is
made from a Bluetooth-enabled device to the
unit�
"On": The input will automatically become
"BLUETOOTH" when a Bluetooth-enabled
device is connected�
"Off": The function is disabled�
● If the input is not switched automatically, set
to "Off" and change the input manually�
Auto Reconnect On This function automatically reconnects to the
Bluetooth-enabled device connected last when
you change the input selector to "BLUETOOTH"�
"On": Use this function
"Off": Do not use this function
● This may not work with some Bluetooth-
enabled devices�
Pairing Information – The information of the previous pairing stored in
this unit will be initialized�
Pressing Enter when "Clear" is displayed
initializes the pairing information stored in this
unit�
● This function does not initialize the pairing
information on the Bluetooth-enabled device�
When pairing the unit again with the device,
be sure to clear the pairing information on
the Bluetooth-enabled device in advance�
For information on how to clear the pairing
information, refer to the Bluetooth-enabled
device's instruction manual�
Device – Displays the name of the Bluetooth-enabled
device connected to the unit�
● The name is not displayed when "Status" is
"Ready" or "Pairing"�
Setting Item Default Value Setting Details
Status – Displays the status of the Bluetooth-enabled
device connected to the unit�
"Ready": Not paired
"Pairing": Pairing
"Connected": Successfully connected
● Wait for a while if "Bluetooth" cannot be selected� It will appear when the Bluetooth function is started
up�
12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V TRIGGER
OUT A jack� Different settings can be set for each input selector� You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack�
Setting Item Default Value Setting Details
Delay 0 sec Set after how many seconds the 12V trigger
output will occur in response to the unit's
operation� As some devices cause a large
current when they turn on, delay the output if
such devices are connected� Select a value
between "0 sec" to "3 sec"�
BD/DVD Main Set the 12V trigger output setting to each
input�
"Off": No output
"Main": Output when "BD/DVD" is selected as
input for main room�
"Zone2": Output when "BD/DVD" is selected
as input for ZONE2�
"Main/Zone2": Output when "BD/DVD" is
selected as input for main room or ZONE2�