1
1
1
Use the AV receiver’s input selector buttons to select an input source.
To select an input source with the remote controller, press its [Receiver]
Remote Mode button, and then use its Input Selector buttons.
Press the [Net/USB] button repeatedly to select Server, USB, or Internet radio
(DTR-9.9 only).
2
Start playback on the source component.
When you select DVD or another video component, on your TV, you’ll need to select
the video input that’s connected to the AV receiver’s COMPONENT VIDEO MONI-
TOR OUT 1, COMPONENT VIDEO MONITOR OUT 2/ZONE 2 OUT, HDMI OUT
MAIN, HDMI OUT SUB, or MONITOR OUT.
On some DVD players, you may need to turn on the digital audio output.
3
To adjust the volume, use the Master Volume control, or the remote con-
troller’s VOL [q]/[w] button.
The volume can be set to
−∞ dB, −81.5 dB through +18.0 dB (relative display).
The AV receiver is designed for home theater enjoyment. It has a wide volume range,
allowing precise adjustment.
The volume level can also be displayed as an absolute value. See “Volume Setup” on
page 125.
4
Select a listening mode and enjoy!
See “Using the Listening Modes” on page 92.
To Next Page
Loading...
Need help?
General
