EasyManua.ls Logo

Intel 460GX - RTCCFG-Real Time Clock Configuration Register (Function 0)

Intel 460GX
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Intel® 460GX Chipset Software Developers Manual 11-9
LPC/FWH Interface Configuration
These registers provide the base address for distributed DMA slave channel registers, one for each
DMA controller. Bits 5:0 are reserved to provide access to a 64 byte I/O space (16 bytes per
channel). The channels are accessed using offset from base address as follows (Note that Channel 4
is reserved and is not accessible).
11.1.20 RTCCFGReal Time Clock Configuration Register
(Function 0)
Address Offset: C8h
Default Value: 00h
Attribute: Read/Write
This register is used to configure the internal Real Time Clock.
Base Offset Channel
00 - 0Fh 0,4
10 - 1Fh 1,5
20 - 2Fh 2,6
30 - 3Fh 3,7
Bits Description
15:6 Base Pointer: I/O Address pointer to DMA Slave Channel registers. Corresponds to PCI
address AD[15:6].
5:0 Reserved.
Bits Description
7:5 Reserved.
4 Lock Upper RAM Bytes: 0 = Upper RAM data bytes 38h-3Fh in the extended bank are
readable and write-able (default). 1 = Upper RAM data bytes 38h-3Fh in the extended bank
are neither readable nor write-able. This is used to lock bytes 38h-3Fh in the upper 128-byte
bank of RAM. Write cycles will have no effect and read cycles will not return an expected
value.
Warning: This is a write-once register that can only be reset by a hardware reset. No
software means is possible to reset this bit.
3 Lock Lower RAM Bytes: 0 = Lower RAM data bytes 38h-3Fh in the standard bank are
readable and writeable (default). 1 = Lower RAM data bytes 38h-3Fh in the standard bank are
neither readable nor writeable. This is used to lock bytes 38h-3Fh in the lower 128-byte bank
of RAM. Write cycles will have no effect and read cycles will not return an expected value.
Warning: This is a write-once register that can only be reset by a hardware reset. No
software means is possible to reset this bit.
2 Upper RAM Enable: 0 = Accesses to RTC Upper 128 byte extended bank at I/O address 72-
73h is disabled. 1 = Accesses to 72-73h are forwarded to RTC Upper 128 byte extended
bank.
1:0 Reserved.

Table of Contents

Related product manuals