Figure 18. The GPIO Tab
The following sections describe the controls on the GPIO tab.
User LEDs
The User LEDs control displays the current state of the user LEDs. Toggle the LED
buttons to turn the board LEDs on and off.
SPI Access Over MAX10
SPI Access Over MAX10 allows you to read and write the data at the address you
specify.
Qsys Memory Map
The Qsys Memory Map control shows the memory map of bts_config.sof design
running on your board.
4.2.5. The XCVR Tab
The XCVR tab allows you to run transceivers tests on your board. You can run the
QSFPDD test using optical fiber modules.
4. Board Test System
683288 | 2022.09.22
Intel
®
Agilex
™
I-Series FPGA Development Kit User Guide
Send Feedback
28
To Next Page
Loading...
